10
Preparing the line trimmer for use
WARNING!
The line trimmer runs for a few seconds after it has been
switched off. Let the motor come to a complete standstill before setting
the tool down.
Telescopic shaft adjustment (Fig. 6)
1. The line trimmer shaft can be adjusted to suit the
height of the operator.
2. Loosen the telescopic shaft collar (5) by rotating in
a clockwise direction.
3. Adjust the telescopic shaft (11) up or down to the
appropriate height. Tighten the telescopic shaft
collar (5) once adjustment is complete.
Manually increasing the cutting line (Fig. 7)
1. Before starting ensure the cutting line is the
correct length.
2. Push the tab on the side of the spool housing
and then pull on the end of both pieces of line
protruding from the spool housing until it extends
a few centimetres past the edge of the safety
guard (7).
3. Carefully peel off the tape over the cutting blade if
you have not already done so.
Semi-Automatic line feed
1. Depress the On/Off switch and allow the line trimmer to reach full speed.
2. Release the On/Off switch and allow the line trimmer to come to a stop or
until you hear a click. repeat steps 1 & 2 until required length is achieved.
Adjusting the cutting head (Fig. 8)
By adjusting the cutting head angle to any of the 11
preset angles the line trimmer can be used to trim
under low hanging branches and shrubs or garden
furniture.
Depress the head angle lock button (6) and adjust the
cutting head to the desired angle. Release the button
(6) and ensure that the cutting head locks in position.
OPERATION
Fig. 6
Fig. 7
Fig. 8
!!
5
11
7
Remove
Tape
Line
Tab
6
Summary of Contents for LTR-300
Page 1: ......
