Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
• Keep the ventilation vents of the trimmer clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the trimmer housing to ensure it is free from
all dust particles which may build up. Build up of dust particles may cause the
trimmer to overheat and fail.
• If the enclosure of the trimmer requires cleaning, do not use solvents but
a moist soft cloth only. Never let any liquid get inside the trimmer; never
immerse any part of the trimmer into a liquid.
Carbon Brushes
When the carbon brushes wear out, the trimmer will spark and/or stop.
Discontinue use as soon as this happens. They should be replaced prior to
recommencing use of the trimmer. Carbon brushes are a wearing component
of the trimmer therefore not covered under warranty. Continuing to use the
trimmer when carbon brushes need to be replaced may cause permanent
damage to the trimmer. Carbon brushes will wear out after many uses but when
the carbon brushes need to be replaced, take the trimmer to
an electrician or a power tool repairer for a quick and low cost
replacement. Always replace both carbon brushes at the same
time.
Note: Ozito Industries will not be responsible for any
damage or injuries caused by the repair of the trimmer by an
unauthorised person or by mishandling of the trimmer.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Wear eye protection
Warning
Regulatory Compliance Mark
(RCM)
V
Volts
Hz
W
Hertz
~
n
0
/min
Alternating Current
Watts
No load speed
Revolutions or reciprocations
per minute
Read Instruction Manual
SYMPTOM
POSSIBLE CAUSE
REMEDY
Trimmer will not
operate or trimmer
runs slowly.
No power supply
Check that the power
is available at source
Blunt or damaged router
bits
Resharpen or replace
router bits
Motor is overloaded
Reduce excessive
load or force on
trimmer
Excessive Vibration Bent router bit shaft
Replace router bit
Light sparking
visible inside the
housing
This does not indicate a
problem
There is no remedy
required
Heavy sparking
occurs inside the
motor housing
Brushes not moving
freely
Disconnect power,
remove brushes,
clean or replace
