Note:
Adjust the trimmer base to the top position (0cm) or remove
completey to access the collet.
The trimming guide allows you to trim off a precise amount of material
off the edge of the workpiece.
2. CHANGING ROUTER BITS
3. TRIMMING GUIDE
Removing Router Bits
Fitting the Trimming Guide
Adjusting the Trimming Guide
Installing a Router Bit
1 Place the small spanner onto
the spindle and the large
spanner onto the collet nut.
1 Loosen the fence/guide
locking screw and insert the
trimming guide.
1 Loosen the trimming locking
knob to allow the lower plate
to slide.
3 Once the distance has been
set, secure in place with the
trimming locking knob.
3 Secure in place by tightening
the fence/guide locking screw.
3 Remove the router bit from the
spindle.
3 Place the small spanner onto
the spindle and large spanner
onto the collet nut..
4 Tighten the collet using the
large spanner.
1 Place the router bit into the
spindle.
2 Loosen and remove the collet
nut by rotating anti-clockwise
with the large spanner.
2 Set the height of the trimming
guide just below the router bit
when it is completely lowered.
2 Set the trimming size
by rotating the trimming
adjustment knob.
(Clockwise for a larger trim)
2 Screw the collet nut finger tight
over the spindle.
min 3mm
