V GROOVE BITS
Used to create V shaped channels or flutes in a workpiece.
ROUTER BITS
Below is a list of the router bits that can be used with this laminate trimmer.
This laminate trimmer is designed for use only with 1/4” (6.35mm) bits. The max diameter of the head of the bit should be less than
32mm to fit the trimmer base.
FLUSH TRIM BITS
Suited to trimming the edge of one piece flush with the edge of
another piece. A common use is using a pattern or template to
create multiple identical shapes of the pattern.
ROUND NOSE BITS
Similar to the V-groove bit in that it creates channels or flutes
in a workpiece.
DOVE TAIL
Most commonly used to create tails for dovetail joinery. Plunge
cuts a flat bottom with angled sides into a workpiece.
CHAMFER
Cuts a 45-degree angle on a square edge.
COVE BIT
Used to create a concave, rounded edge to a piece of timber.
Often used in conjunction with a round over bit.
ROUND OVER BIT
Creates a rounded edge on a piece.
STRAIGHT BITS
Straight router bits a ideal for making plunge cuts into a material
to form a groove or to hollow out an area for a mortise or inlay.
