![background image](http://html1.mh-extra.com/html/ozito/ltm-3000/ltm-3000_instruction-manual-for-the-use-and-the-maintenance_1666411005.webp)
LTM-3000
6. CONTROLS
7. MAKING A CUT
OPERATION
Adjusting the Cutting Depth
1 Loosen the guard locking
knob.
3 Secure in place by tightening
the guard locking knob.
2 Adjust the cutting depth by
rotating the depth adjusting
screw.
Switching On and Off
1 To start the trimmer, push
the on/off switch into the on
position.
2 To stop the trimmer, push
the on/off switch into the off
position.
OFF
ON
OFF
ON
1 Hold the laminate trimmer,
making sure your fingers are
clear of the opening in the
trimmer guide base.
2 Place the trimmer guide base
onto the workpiece so that the
router bit overhangs the edge.
3 Switch the laminate trimmer
on by pushing the on/off switch
into the on position.
4 Follow the below guide to assist you when cutting or trimming your
workpiece. This is to ensure the chips are removed away from the
operator.
Note:
On harder woods it may be necessary to make more than one
pass at progressive cutting depths until the desired depth is
achieved.
OFF
ON
Direction of the router travel
When routing the outside
of your workpiece
When routing the inside of
your workpiece
Before starting, perform a few quick checks:
* Ensure the correct router bit is installed.
* Ensure the trimmer guide base is secure.
* Check the depth of cut is set to your desired depth.
* If using any of the guides or fences, check they are properly fixed
to the laminate timmer.
* Make sure the workpiece is secure and won’t move during
operation.
KEEP CLEAR
WARNING!
TO REDUCE THE RISK OF ELECTRICAL
SHOCK, WE RECOMMEND THE USE OF A RESIDUAL
CURRENT DEVICE (RATED 30mA OR LESS).
WARNING!
INJURY MAY OCCUR IF YOU HOLD THE
TRIMMER INCORRECTLY. KEEP FINGERS CLEAR OF
THE ROUTER BIT AT ALL TIMES.
WARNING!
ENSURE THE TRIMMER IS SWITCHED OFF
BEFORE ADJUSTING THE CUTTING DEPTH.