Loading The Soap Dispenser
1. Flip open the lid on the soap bottle.
2. Pour in the required amount
of car wash detergent.
3. Dilute the detergent as
directed by the detergent
manufacturer’s instructions.
4. Replace the lid on the soap bottle.
Note:
The foam dispenser nozzle must be used in order to discharge
soap from the unit. If the adjustable width nozzle is used, only water
will be pulled through the system.
Changing Detergents
1. Remove any remaining detergent from the soap bottle.
2. With the foam dispenser nozzle attached, continuing spraying until
only water is emitted from the nozzle.
3. Fill the soap bottle with the second detergent. Use as normal.
3. USING DETERGENT
3. CONTROLS
OPERATION
Detergent
Water
Starting & Stopping The Unit
1. Rotate the on/off dial to the ‘I
| ON’ position to turn the unit
on.
2. Unlock the spray gun by
pushing the trigger lock
towards the right side of the
gun.
2. Squeeze the spray gun trigger
to start spraying.
3. Release the trigger to stop spraying.
4. Rotate the dial to the ‘0 | OFF’
position to turn the unit off.
WARNING!
DO NOT LEAVE THE UNIT IDLING IN
THE ‘ON’ POSITION FOR MORE THAN 5 MINUTES
WITHOUT ACTIVATING THE SPRAY GUN. DOING SO
MAY DAMAGE THE PUMP IN THE UNIT.
HIGH PRESSURE WASHER
0 | OFF
I | ON
HIGH PRESSURE WASHER
0 | OFF
I | ON
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.
WARNING!
NEVER RUN BLEACH OR DETERGENTS
NOT DESIGNED FOR PRESSURE WASHERS IN THE
UNIT TO PREVENT DAMAGING THE PUMP.
WARNING!
THE POWER SUPPLY FOR THIS
PRODUCT MUST BE PROTECTED BY A RESIDUAL
CURRENT DEVICE (RATED AT 30mA OR LESS).