![background image](http://html1.mh-extra.com/html/ozito/hpw-2400/hpw-2400_instruction-manual_1666643003.webp)
Connecting The Water Supply
This pressure washer requires a pressurised water source with a
maximum pressure of 0.6MPa (87psi). It is recommended that a
reinforced garden hose (with minimum diameter of 12mm) is used for
the inlet connection. It cannot be used with a bucket and siphon.
WARNING!
RUN WATER THROUGH THE GARDEN
HOSE BEFORE ATTACHING IT TO THE PRESSURE
WASHER TO PREVENT ANY SAND OR DIRT FROM
ENTERING THE UNIT.
1. If it is not already fitted, place
the mesh inlet filter into the
hose adaptor, and then screw
this onto the water inlet port.
Note:
The mesh inlet filter must
be in place to prevent impurities
in the water source from entering the unit and damaging the pump.
WARNING!
ENSURE THE GARDEN HOSE IS
ADEQUATELY RATED AND SUFFICIENTLY LONG
FOR THE INTENDED APPLICATION.
2. Push the standard quick
coupling adaptor on the end
of the garden hose onto the
hose adaptor on the pressure
washer until it clicks into
place.
Note:
The standard quick
coupling adaptor should have an
external diameter of 16mm and an internal diameter of 12mm.
3. Pull gently on the hose to ensure the connection is secure.
Connecting The Pressure Hose
1. Push one end of the 5m pressure hose into the water outlet port on
the back of the pressure washer until it clicks into place.
2. Gently tug on the pressure
hose to check that the
connection is secure.
3. To disconnect the pressure
hose, press and hold the
quick release button on the
water outlet port while pulling
the hose out.
Attaching The Spray Gun & Lance
1. Push the tab end of the lance into the spray gun and twist
clockwise to lock it into place.
2. Push the end of the pressure
hose into the inlet port on the
spray gun until it clicks into
place.
3. Tug gently on the pressure hose to check that it is inserted
correcly.
4. To disconnect the spray gun,
press and hold down the
quick release tab and pull out
the pressure hose.
5. Twist the lance anti-clockwise against the spray gun to detach it.
Attaching The Nozzles
1. Align the tabs on the nozzle
to the slots on the front end of
the lance.
2. Push the nozzle into the
connector end of the lance
until it clicks into place.
3. To detach the nozzle, press
and hold down the quick
release button on the nozzle
whilst pulling it off.
2. INSTALLING ACCESSORIES
a.
b.
a.
b.
a.
b.
a.
b.
a.
b.
WARNING!
ENSURE THE TOOL IS TURNED OFF
AND DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS.