1. Remove the plastic protection
cover from the discharge outlet.
2. Wrap the discharge outlet with
Teflon tape.
3. Insert a 1” female threaded
adaptor (not included).
4. Securely attach the output hose
or pipe (not included) to the other
end of the adaptor. Ensure you
have the correct diameter hose
or pipe that is compatible with
your water discharge application.
Note:
The discharge hose or pipe
you are using must have a minimum
diameter of
19mm (3/4’’).
Note:
Ensure the discharge hose or pipe is not restricted in any
way and nothing is obstructing the hose or pipe when the pump is in
operation.
1. Teflon tape is required on threads to ensure
a water tight seal and prevent any leakage.
Wind Teflon clockwise on fittings.
2. Remove the plastic protection
cover from the suction inlet.
3. Insert 1” male threaded adaptor
(not included). Tighten firmly with
a spanner (not included).
4. Securely attach the input hose or
pipe (not included) to the other end
of the adaptor. Ensure you have
the correct diameter hose or pipe
that is compatible with your water
drawing source.
Note:
The suction pipe should have
an internal diameter of at least
25.4mm (1”); it must be kink resistant
and suitable for pump use. Ensure the input hose or pipe is not
restricted in any way.
2. SUCTION INLET
3. DISCHARGE OUTLET
WARNING!:
RISK OF INJURY! IF THE COMPONENTS
ARE NOT COMPRESSION-PROOF OR IF THEY ARE
IMPROPERLY INSTALLED, THE PRESSURE LINE COULD
BURST DURING OPERATION.
Connecting to the suction inlet
The inlet allows for a 25.4mm (1”) supply line to be connected.
Note:
The Ozito TPIK-025 Tank to pump installation kit is available
from Bunnings stores and may assist in your installation.
Connecting to the discharge outlet
The outlet allows for a 25.4mm (1”) delivery line to be connected and
is capable of a maximum head of 33m
