8. OPERATING THE PUMP
Cleaning
Use a moist cloth to wipe down the pump housing. Allow to dry
thoroughly before storing in a dry location that is protected from bad
weather conditions.
Storage
If there is danger of frost, dismantle the device and accessories, clean
and store them in a place protected from frost.
Dismantle and store
1. Disconnect the device from the
mains supply.
2. Fully open any shut-off
mechanisms (spray nozzles,
valves, etc.) in the pressure
line so that the air can escape
without obstruction.
Note:
Ensure the gate valve on your
water tank is not left open as this will
allow water to drain from the tank.
3. Completely empty the pump
by dismantle the suction and
pressure lines from the device.
4. Store device in a frost-free room
(at least 5 °C).
WARNING!
MAKE SURE THE PUMP IS DISCONNECTED
FROM ELECTRIC POWER SUPPLY BEFORE
PERFORMING MAINTENANCE PROCEDURES.
WARNING!
MAKE SURE THAT THE DEVICE AND
CONNECTED ACCESSORIES ARE DEPRESSURIZED
BEFORE CARRYING OUT ANY WORK ON THE DEVICE.
MAINTENANCE
OPERATION (cont.)
Pump Control Unit
‘GREEN Power on’.
This indicates that there is power to the
pump, but the pump is currently not on.
‘ GREEN Pump on’.
This indicates that there is power to the
pump and the pump is running.
‘RED F GREEN’.
There is power to the pump, but flow is
stalled. In this event, press the Restart
button.
If the malfunction still occours, refer to the
“
TROUBLESHOOTING”
section to find a
remedy.
‘RESTART Button’.
When the pump requires restating (Failure
light illuminates red), push the Restart
button and hold for 5 seconds to re-start
the pump, the red failure light should
turn off. If the failure light re-illuminates
red, refer to the “
TROUBLESHOOTING”
section to find a remedy.
Note:
If all three lights are on; the Pump has detected a failure, but will
continue to run for approx. 10 seconds to attempt to fix the problem.
