09/10
Instructions
Safety Guidelines
5
咔嚓
Click
After
the
seat
belt
is
fixed, the seat
belt
buckle and belt guide can not be placed in
this position.
Please
contact the manufacturer
if in doubt.
Step 1:Install
the
ISOFIX interface to the
vehicle
seat(see 4.7)
.
Make sure that the ISOFIX
status windows
show GREEN.
Next, push the
ISOFIX
seat
base
towards the
vehicle
seat
backrest until it is firmly pressed against the seat backrest. Then adjust the support leg to
touch the ground completely
, ensure the leg status window shows GREEN
(see 4.6) .
Step 1:Place the child seat on the car
seat rearward-facing and make sure
that the front of the child seat is firmly
pressed against the
vehicle
seat
backrest
.
Note
：
Ensure the infant
carrier base is sitting on the vehicle
seat so that the theoretical points A,B
&C (see opposite) are horizontal.
Step 2:
Pass the belt
diagonally through the belt
guide on the back of the seat.
Diagonal belt
Lap belt
5.2 This child seat can be installed with
the
Capsule
ISOF
IX base
with support leg.
Step 3:
Thread
the lap belt
through
the belt guide on the
other side of
the infant carrier
.
Insert the lap belt into car
seat belt buckle until hear a “click”.
Pull the
vehicle seat
belt
to eliminate any slack
and check to mak
e sure its us securely
fastened
.
Step 4:
Keep the
infant carrier
in a stable position
and place on the vehicle
seat
. Hold
the infant carrier
handle adjuster
buttons
with
both
hands
; squeeze
the red buttons and a
t the same time
push forward
the handle against the
backrest of the car seat
as pictured
. Make sure the seat belt is free of twist
s
and
follows a smooth route
.
Remove any slack from the seat belt
.
5
WARNING
:
This child (seat) restraint must be installed rear facing.
5.1 This child seat can be installed with adult 3-point belt as an infant carrier module.
INSTALLATION
INSTALLATION
