19
5.1.
Positioning
Place the device onto a solid surface as high above the floor as possible
(e.g. on a shelf or wardrobe), in order to allow for optimal air circulation.
For maximum effect, the air purification device ought to not be positioned
near a waste air ventilator.
If the device is to be permanently installed (e.g. in cooling chambers), it is
to be mounted at least
2,50
metres above the floor on the wall or below
the ceiling.
5.2.
Commissioning and Operation
1.
Connect the Freshair via the power plug (E) to a grounded
230
Volt
mains connection.
2
. Close the windows and turn off ventilation.
3
. Operate the flip switch (D), in order to turn on the air purification
device. The control light at the flip switch will come on. The status
light of the photozone lamp (C) comes on steady green (and/or it
flashes red after
10 000
hours of operation).
4
. There will be a crackling hum.
5
. The device may heat up during operation.
6
. To turn off the device, operate the flip switch (D), the control light
goes off.
7
. Pull the power plug (E).
5.3.
Duration of Treatment
The Freshair has been designed for permanent use in indoor rooms.
Optimum application of the Freshair depends on type of use, on type and
5
.
operation
Bedienungsanleitung_Freshair_2014-1.indd 19
25.02.14 11:12
