www.oxygenautomation.com
All rights reserved
Pag
.
5
ELECTRIC STANDAD WIRING LAYOUT
PARIS PRELIMINARY CHECKS GATE
To ensure correct operation, the gate must have the following qualifications:
- Robust and rigid structure of the doors;
- The movement of the leaves must be regular and uniform but also devoid of friction during travel;
- The hinges must be in good condition;
- Mechanical stops at the end of the race positioned.
Any metalwork operations should be carried out before the installation of the automation. The state of the
structure of the gate influences the reliability and safety of the automation.
INSTALLING PARIS 240 - FIXING PARIS 240
A) Fasten the rear attachment on the pilaster, following the indications of the table A, modify if necessary,
the length of the bracket (Fig. 1).
Compliance with the dimensions shown in the above tables ensures correct operation. In the case of iron
pillar carefully weld the rear attachment directly on the pillar.
In the case of masonry pillar opt for one of the following solutions:
1) appropriately Cashing a plate to wall and then weld the rear fitting;
2) Attach to the pillar with screws and anchors the rear mounting plate and weld on the rear
mounting plate (Fig. 2)
B) Fix the operator to the rear (fig. 2);
C) Release the hydraulic actuator PARIS 240 with release key;
D) Remove the chrome stem until total joke and bring it within approximately 5 mm (Fig. 3), and only in the
case of PARIS 240-SB installation tighten in half the front fitting (joint head) on the stem and tighten with
the supplied nut (fig. 3.1);
E) Fit the front attachment onto the rod (Fig. 4);
F) Close the gate leaf keeping the actuator perfectly horizontal and locate the front of the attack on the
wing (Fig. 5);
G) temporarily fix the front attachment on the gate using two weld points (protect the stem from any
welding slag) (fig. 6);
H) Unlock the PARIS actuator, manually check if the gate is free to open and stop the mechanical stops to
end preinstalled race; Furthermore, check the movement of the gate is regular and without friction;
I) momentarily disconnect the actuator and weld the front attachment on permanently (fig. 7)
L) Place the cover on the actuator rod PARIS (fig. 7);
M) Re-lock the PARIS actuator and make the electrical connections with the electronic equipment,
according to the instructions in the manual.
