Praktika T-04(K) speedgate
16
Fig. 8 General view of motherboard
CAUTION (!) Operating mode of speedgate is defined by setting the
jumpers on motherboards of both side units of the speedgate.
Table 3 Operating mode of speedgate
The position of jumpers
Operating mode of speedgate
J1 removed
Pulse mode (see article 5.3.)
J1 installed
Potential mode (see article 5.3).
J2 installed
Speedgate does not respond to the remote
commands. Status of the buttons is transmitted
to the outputs I / O1 ... I / O4 (see article 5.4)
J2 removed
Speedgate is controlled by remote control.
Status of the buttons is transmitted to the
outputs I / O1 ... I / O4 (see article 5.4)
- Jumper J3 is not used
- Jumper J4 is used to establish the normal operation of CAN2.0 bus. See
Appendix 1.
