46 GB/IE
Return / Clear
Press “Return / Clear“ button
8
at any mode to clear latest
measured value and go back to previous value (or) go back
to previous mode.
Press “Return / Clear“ button
8
multiple times to go back
to Home-screen mode (see chapter “Start-up“, section “Home-
screen mode“).
Note:
Pressing “Return / Clear“ button
8
under continuous
measurement mode will stop the measurement.
Selection of the reference point
The reference point (back)
29
(base) or the reference point (end
piece)
28
or the reference point (front)
30
of the product can be
used as the contact surface for any measurement. The reference point
is to be set before measurement. Otherwise, the measured result
differs from actual value. The default reference point setting is from
the reference point (back)
29
of the product. The reference point
can be changed by pressing the reference button
12
repeatedly
until the desired reference point shown on the top left side corner
of the display.
End piece reference point
The end piece at the reference point
33
will be useful while a
distance is measured from a corner (diagonal room) or from the
place, where it is difficult to reach. The end piece at the reference
