Hydra 3000 Uno Technical Manual
Doc Part No.: OVZ20041
© Overview Ltd. 2020
Page 15 of 74
Revision: 01
This is the property of Overview Ltd. No copying without permission.
9.1.
Installation
–
Mechanical
9.1.1.
PTZ Camera Unit
Warning:
The PTZ Unit is a sealed unit containing no user serviceable parts. The
housing should not be dismantled by the user. Return to the supplier for
rectification of any faults.
See Appendix 2 for a list of approved mounting bracket kits and accessories
The PTZ unit may be installed with the base at the bottom e.g. on a specially designed pole.
It may also be mounted with the base at the top, e.g. suspended from a suitable bracket. The
camera must NOT be installed with the axis of the pan arm in the horizontal plane.
Figure 9 Allowable Mounting Positions for PTZ Unit
The following points must be observed:
I.
Power must not be connected to the PTZ unit until it is securely fixed to the point of
installation and all connections have been made.
II.
A lug should be provided at the mounting point to which the maintenance lanyard
can be attached during installation. See Figure 11.
III.
Sufficient space should be allowed around the camera so that it is free to rotate
through its full movement in all directions. See Figure 12.
IV.
Provision should be made in the mounting point to route the cables away from the
base of the camera using conduit or by routing through a protected route, such as
the inside of a mounting pole.
V.
The Hydra 3000 spacer should be mounted to the base of the PTZ unit using screws,
nuts and washers provided.
