Overmax Multipic 4.2, User Manual

Page: 18 / 78

EN
Supported formats
Picture formats: BMP/JPG/PNG/JPEG
Video formats: MP4/MKV/WMV/RMVB/RM/AVI/FLV/TRP/VOB/3GP/DIVX/
TP/TS/MPG/M2TS/F4V/DAT
Audio formats: MP3/AAC/FLAC/WAV/WMA/M4A
File formats: TXT
Note:
this device does not support Dolby-encoded audio for copyright protection
reasons.
Use of the device
Start and turn off the device
1.
Plug the power cord into the device and then connect the device to the
power supply.
2. Push the on/off button on the remote controller or projector (A, fig. 1).The
indicator light will be lit solid blue.
3.
After about 2 seconds, the device will be enabled and the picture will
appear on the screen. The device will switch into standby mode.
4.
The picture may be blurred or distorted, when the device is turned on for
the first time (adjust it, see: “Picture focus adjustment and keystone
correction”).
5.
To turn off the device, push the on/off button on the remote controller or
projector. The device will switch into sleep mode.
6.
After switching into sleep mode, the device will start the automatic heat
dissipation process. The indicator light will turn red.
Picture focus adjustment and keystone correction
1.
Place the projector so that the lens remains perpendicular to the wall or
screen, on which the picture will be displayed.
2. To correct the focus of the displayed picture, turn the focus knob (A, fig.
2) until the image is focused. During picture focus adjustment, you can
continue to use the product.
3.
Use the keystone correction knob (B, fig. 2) to adjust the shape of the
picture (fig. 3). Note! Only vertical mechanical keystone correction is
available. Make sure the projector is at the same level as the displayed
picture.
Projector installation methods (fig. 16)
For projector installation under the ceiling, contact a professional installer.
1. Ceiling mount for front projection.
2.
Placing the projector on a front projection stand.