[8]
Different chemistries have their own specifications, so it is important that the correct program is
selected before any operations are started. The following programs are only suitable for charging
and discharging Lithium batteries:
(Lithium Battery Program Icons)
Enter the Lithium Battery Program Menu and select the Charging Program. Press “Start” for 2
seconds to enter the menu where you can enter the charging parameters.
Please set the charge current according to the battery capacity and performance. The cell count
of the battery is also very important, so make sure the current and nominal voltage are set
correctly before beginning the charging process.
After setting the Lithium battery charge parameters, press “START” for 2 seconds to enter the
Lithium Charge Mode Menu. Press “Back” to go back to the previous menu if you wish to reselect
the battery type and program.
7.1. Lithium Battery Charging
Up
7. Lithium Battery Program
Up
“Cell 6S”
Charges 1-6S. Select the cell count of the
batteries you wish to charge.
“CAPAC 5.0Ah”
Maximum charge capacity setting.
Select the capacity of the battery.
“CURR 10A”
Charge current setting (0.1-10A). Select
the charge rate you wish to charge your battery at.
“ENDV 4.20”
This is the maximum voltage that each
cell within the battery will charge to. This voltage is not
to be exceeded.
“Back”
Takes you back to the previous menu.
Increase/up button.
Decrease/down button.
“START”
Start/confirm button.
“Set:6S Read:6S”
This checks the cell count.
There are three Charging Modes for Lithium battery
charging:
“Balan”
Balance Charge Mode
“Charge”
Normal Charge Mode
“Fast”
Fast Charge Mode
Summary of Contents for TS80
Page 1: ......
