3.13
Set Configuration
Reset the AfterBurner system configuration to factory defaults and enable load-system-
configuration from CD or DVD disk.
Set Configuration
===================
Default values? No
Load CD/DVD ini? No
Default values?:
if set to “yes” and the
M
key pressed, the unit’s system
configuration will be returned the factory default settings.
Load CD/DVD ini:
if set to “yes” AfterBurner will attempt to load its system
configuration from the DVD in the drive the next time the drive is
accessed.
This mode allows a number of AfterBurners to be easily setup with
the same system configuration. AfterBurner burns its current
system configuration as a small “.ini” file to each DVD. With this
option activated, AfterBurner will attempt to read and install the
configuration file next time the DVD drive is activated.
NB:
This mode is automatically disabled after use and / or at power
down.
3.14 System
Information:
System information:
Version: 1.3 5349
Serial No. 1223
Disk capacity 250 GB
See Section 7, page 35 for more information about the version number and how to
upgrade the system firmware.
4 Rear Panel Interface
