E-25-7-E
23
9.1.2.1 Operation (setup mode)
On seeing that the entire front panel LCD1 is blinking (by the previously outlined steps), you can change
parameters and variables as follows. The procedure to enter a numerical value remains the same as
“Example of Batch Setup” in the previous section. Refer to that section. The LCD readings shown below
are factory default settings.
Setup Mode
LCD1 blinks.
If you go down to the next step without any
setpoint changes.
00000000
to 99999999
(8-digit)
Total counter setting at 0
Total
reading
Change
Change
Change
Change
Change
Change
Change
Adjust
numerals.
Shift
Setup
Set up numeric value
with two control keys.
0.001
to 1.9999
Scale factor at 1.0000
Scaler
0:1/1 1:1/10
2:1/100
Frequency divide at 0 (1/1)
Freq.
divide
0 to 999
counts
(3-digit)
Initial setting at 80
Initial
setting
0 to 999
counts
(3-digit)
Final setting at 80
Final
setting
0 to 15 sec
(2-digit)
Missing pulse setting at 10 sec.
Missing
pulse
setting
0 to 99
counts
(2-digit)
Overmeasure setting at 10
Overmeas.
setting
CAUTION: Upon completion of all setup procedures, turn off power and return the toggle
switch to “RUN”.