E-25-7-E
5
(2) End-of-batch output
When a flow signal reaches the target batch quantity during a batch process, an output is produced.
The LCD END then comes on and completes a circuit across terminals 9 and 0 (Non-contact relay
output, Form “a” contact).
(3) Scaler
If incoming pulse signal is of unfactored pulses, a constant inherent to the flowmeter used is multiplied in
the scaler; conversion takes place into quantities in industrial engineering units of measure in integer; the
resultant quantities are used for batch processes.
For the setup procedure, refer to Sec. 9..
(4) Input frequency division (scaling)
There are two approaches in setting up the input frequency division. One is a frequency reduction by
hardware, using a jumper and the other is a frequency reduction by software, using the front panel control
keys.
For the setup procedure, refer to Sec. 9. and 9.5.
