L-770HP--E
Parameter
Descriptions
Setting range
Standard value
Temp unit
Temperature unit
Refer to the list of setting units.
℃
Temp damp
Temperature damping
0 to 00 [sec]
. sec
[Temperature parameters]
Parameter
Descriptions
Setting range
Standard value
Assign
Pulse output assignment
Mass Flow
Volume Flow
Mass Flow
Mode
Output valid / invalid setting
Normal (valid) /
Stop (invalid)
Normal
Freq Factor
Full-scale frequency of pulse output
※
This is not the higher limit of output
frequency. Depending on the
flowrate, output will be generated
even if frequency exceeds the set
value.
0. to 0000 [Hz]
000 Hz
Rate Factor
Full-scale flowrate of pulse output
―
According to the
specification
Lowcut
Low cut of pulse output.
Setting will be done by certain
percentage value to the Rate Factor
and pulse output will be cut off if
below set range.
0 to 0 [%]
0 %
Error output
Pulse output status upon
occurrence of an error
Zero
:
Stop output
Hold
:
Output retention
Upscale
:
Pulse upscale freq
Zero
Pulse upscale freq Pulse output frequency during
upscaling
0. to 000 [Hz]
000Hz
8.5 Pulse Output Function
By using the pulse output function, the measurement values can be output from the PULSE terminal.
By changing the pulse output assign, full-scale flowrate or full-scale
frequency, the total counter and the total flowrate value (Counter / Totalizer)
will be reset.
〈
CAUTION
〉