5
In case of rain retract the awning if tilt angle is less than 14°.
Nobody is allowed to climb onto the awning. Hanging anything on the awning is
forbidden.
Sheeting was used to protect the paint. This must be removed afterwards.
When extended, various forces, including wind and rain, will affect an awning. These
sometimes substantial forces must be absorbed by the awning and transferred to the
assembled structure via its mounting brackets. Under extreme loads, excessive
attractive force can be exerted on the anchor bolts. Therefore,
before starting
assembly, check the load-bearing capacity of the mounting base and if
necessary take corresponding measures to ensure stable installation of the
brackets.
If the mounting base is unstable, you have to consult a specialist in your vicinity.
Assembly
Please read follow item before assembly
1).At least two adults are needed to move and install the awning as the product is big and heavy.
2).Please use all the screws and nuts tighter during installation as it is very dangerous if you leave it loose.
3).Do not cut the strings before the awning completely mounted on the wall.
4).Be careful with your finger during installation.
5).Take out the hand crank from loop after adjusting the awning as you wish and put it on a place that is not be touched
by children.
Tools required:
Step 1: Roller assembly
Keep the rollers aligned, assemble the roller with the connectors and secure it with the corresponding bolts as figure
below:
