5
Plugging In and Turning On
The Creamsource should only be used with the supplied power sup
-
ply. The input is auto-ranging from 90-250V AC, 50/60Hz so can
be used world wide.
Connect the power cable with the power turned off on the power
supply to extend the life of the connectors. The Creamsource
remembers its last brightness setting, and also if the light was turned
on or off. It also remembers the last MODE it was used in.
Up to 15m (50ft) of extension cable can be run between the power supply and the head.
To prevent overheating, care must be taken not to block cooling slots on the power supply. It is
not advisable to stack power supplies on top of one another.
The unit can also be run off 24V - 32V battery packs, providing they have the required current
capability. See page 14 for more information on running with batteries.
If the external flexible cable of this luminaire is damaged, it must be replaced by
an original cable from the manufacturer or service agent.
Turning Off
The power should be switched off on the power supply before unplugging the cable. There are
no other special procedures for powering down - it can be done at any time without harm to the
unit.
Temperature
As the Creamsource is a high power device, it will get hot during normal operation, and care
must be taken when touching the unit.
The maximum surface temperature of the lamp head will be 60 deg C, when operated in ambi
-
ent temperature of 25 deg C
Maximum ambient temperature for normal operation is 40 deg C.
!