THE EDGE
®
LED PARKING STRUCTURE
Surface Mount
1 of 2
CI320X01R1
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your
local electrical code. If you are not familiar with these codes and
requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n’êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3.
When handling, hold fixture on sides to prevent damage to the top
screen or LED’s.
4. Take care to keep the LED lenses clean during installation.
5.
This fixture contains a universal LED driver and can be operated at
voltages of 120V thru 277V.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
MOUNTING- CEILING MOUNT BOX
STEP 1:
Loosen the Phillips head screw holding
the mounting bracket to the fixture cage by
inserting a Phillips screw driver thru the
access hole located on the side
of the fixture cage. Remove bracket.
STEP 2:
Loosen the (2) Phillips head screws holding
the cord plate assembly to the mounting
bracket and remove the bracket.
STEP 3:
Install the mounting bracket to the customer
supplied J-box with the gasket facing the
J-box. Tighten J-box screws firmly. See
Figure 1.
STEP 4:
Route supply wires thru the mounting
bracket. For ease of installation, hang fixture
on mounting bracket hook. See
Figure 2.
NOTE:
For some mounting locations that
would prevent the fixture from sliding into the
mounting bracket, the position of the fixture
cage may be changed. See
Figure 3.
To do
this, remove the (4) screws holding the cage
to the fixture and rotate the cage 90°. Replace
and tighten screws.
STEP 5:
Complete electrical connections as
appropriate. Reference Electrical
Connections section.
STEP 6:
Push excess leads into J-box thru the
mounting bracket and install the cord plate
assembly on the jbox mounting bracket.
Tighten screws firmly.
STEP 7:
Remove the fixture from the hook and slide
the fixture cage over the mounting bracket.
Secure fixture to mounting bracket by
tightening screw removed in Step 1.
2
3
