4 LaserMatrix Floor Model Stacker
UNPACKING & INSTALLA
UNPACKING & INSTALLA
UNPACKING & INSTALLA
UNPACKING & INSTALLATION
TION
TION
TION
You will need a utility knife for unpacking the container
and a small, flat-blade screwdriver to fasten cable connectors.
1.
Inspect shipping container for damage. Report damage to
carrier immediately.
2.
Stand shipping container upright.
3.
Use a utility knife to remove one side of the container.
4.
See Caution below, then move contents to installation site.
! CAUTION !
If you use a lift truck, only lift along bottom rails of the
stacker. Do not use a lift truck after plastic strap has
been removed.
5.
Remove plastic stretch wrap.
6.
Remove accessories box. Also, remove bubble package
resting on refolding deck. Check contents of box and
package against the following illustration.
7.
Cut plastic strap holding cardboard pad to bottom of deck.
8.
Use the screwdriver provided to remove two screws (with
nylon washers) holding printer stand to refolding deck.
Lift off stand and then re-install screws and washers to
deck.
Summary of Contents for LaserMatrix Floor Model Stacker
Page 15: ...LaserMatrix Floor Model Stacker 13 LB0 H1...
Page 32: ......
