24 LaserMatrix Floor Model Stacker
NOTE: Starting the stack
1
/
8
in. from the guides is
important if you plan on a tall stack, and especially when
using lower-quality paper. The perfs of some fanfolded
paper are not always squared well with each other and so,
as the stack grows, it may tend to lean a little. If this
causes a problem, we recommend a different brand of
paper
2
.
12.
When print job is done and you wish to retrieve your
printing, advance the last printed page past the paper chute
and then separate at the perf.
13.
If you used the auxiliary paper guide, slide it out of the
deck channels.
14.
Lift the refolding coils to the tops of their risers.
15.
Use the handles on the paper stack support to slide out and
transport the print job.
Don’t use the flexible platform attached to the wedge of
the paper stacker for carrying the print job. If you do, you
might spill the paper stack. Use the built-in handles on the
paper stack support.
2
If stack-lean interferes with unattended performance, check for bad perforation
alignment. To test for perforation misalignment, turn the box of paper around on
the next print job and check if the stack tends to lean in the opposite direction. If it
does, change brand names. We recommend our own brand of paper (Part No.
LM1000C112) which is manufactured to exacting tolerances for consistent
performance.
Summary of Contents for LaserMatrix Floor Model Stacker
Page 15: ...LaserMatrix Floor Model Stacker 13 LB0 H1...
Page 32: ......
