28 LaserMatrix Floor Model Stacker
Fanfold Paper (LM1000C112)
Fanfold paper manufactured for Output Technology is
optimized for use with the LaserMatrix printer and LaserMatrix
Floor Model Stacker. The paper is white, 24 lb, 8
1
/
2
in. x 11 in.,
fanfold paper (2000 sheets) which stacks to a height of about
11 in.
Paper Motion Sensor (LM1000A119)
The paper motion sensor is not required on LaserMatrix
printers manufactured after May 23, 1994. For these, the control
cable connecting the LaserMatrix printer to the LaserMatrix
Floor Model Stacker allows the LaserMatrix printer to turn on
the stacker only when the printer is printing.
LaserMatrix printers manufactured before May 23, 1994
require a paper motion sensor (Part No. LM1000A119) for
automatic operation. Also, the paper motion sensor is necessary
for automatic operation on other brands of continuous form laser
printers.
The paper motion sensor bolts to two threaded studs on
the underside of the paper chute support. A cable attached to the
sensor is connected to the D-type connector on the refolding
deck.
The table that follows lists part nos. of LaserMatrix
printers that require a paper motion sensor for automatic
operation. For the LaserMatrix printers, read the part no. on a
label on the back of the printer, below the paper exit. The last
two numbers of the part no. (XX) is the revision code for the
printer.
Summary of Contents for LaserMatrix Floor Model Stacker
Page 15: ...LaserMatrix Floor Model Stacker 13 LB0 H1...
Page 32: ......
