20
Outdoor Lifestyles by Hearth & Home Technologies • Palazzo Installation Manual • 4082-311 Rev. A • 06/08/15
• Pipe incoming gas line into lower compartment.
• Connect incoming gas line to the 1/2 in. (13 mm)
connection on manual shutoff valve.
WARNING! Risk of Fire or Explosion! Support control
when attaching pipe to prevent bending gas line.
• A small amount of air will be in the gas supply lines.
Light the appliance. It will take a short time for air to purge
from lines. When purging is complete the appliance will
light and operate normally.
WARNING! Risk of Fire! DO NOT change valve settings.
This valve has been preset at the factory.
WARNING! Risk of Fire or Explosion! Gas build-up dur-
ing line purge could ignite.
• Purge should be performed by qualified service
technician.
• Ensure adequate ventilation.
• Ensure there are no ignition sources such as sparks or
open flames.
WARNING! Risk of Fire, Explosion or Asphyxiation!
Check all fittings and connections with a non-corrosive
commercially available leak-check solution.
DO NOT use
open flame. Fittings and connections could have loos-
ened during shipping and handling.
Valve
Control Box
Gas & Electric
Pass Throughs
Manual
Shutoff Valve
Junction Box
Cover Plate
Figure 6.1 Lower Compartment
D. Valve Access
The valve and controls are located in the appliance con-
trol box. See Figure 6.2.
Prior to finishing materials:
The control box and controls can be accessed from the
front of the appliance, prior to finishing materials being
added to the face of the appliance.
• Remove Lower Access Panel by lifting up on the panel
to disengage from hook, pull panel away from unit and
set aside. See Figure 6.2.
• Remove screws securing control box access panel.
• Remove control box lower access panel.
See Figure 6.3.
Valve Control
Box
Lower Access
Panel
Figure 6.2 Lower Access Panel
Control Box
Access Panel
Figure 6.3 Control Box Access Panel
CAUTION! Damage to appliance may occur.
When test burning the Palazzo appliance, without glass
media installed on hearth pan, do not burn the appliance
for more than 30 seconds, as damage to the stainless
steel hearth pan/burner may occur.
