Introduction
8
900-0198-01-00 Rev A
Welcome to OutBack Power Technologies
Thank you for purchasing the OutBack FX and VFX Mobile Series Inverter/Chargers. These products are
designed to offer a complete power conversion system between batteries, shore power, and generator.
In shore-based mobile and marine connections, the shore power (utility grid) is used as the primary
source. When the shore power is removed, the inverter takes over to run the loads from the batteries.
Figure
1
FX Mobile Series Inverter/Charger with Turbo Fan
Inverter Functions
Battery (DC)-to-AC inverting which delivers single-phase power (120 Vac/60 Hz)
Rapid transfer between AC source and inverter output with minimal delay time
Wattages from 2.0 kVA to 3.6 kVA
12-, 24-, 32-, 36-, and 48-volt models
Uses the MATE, MATE2 or MATE3 System Display and Controller or the AXS Port™ SunSpec Modbus Interface
(sold separately) for user interface
MATE3 must have firmware revision 003.007.xxx or higher
Supports the OPTICS RE™ online tool
1
for a cloud-based remote monitoring and control application
Requires the MATE3 or the AXS Port
Visit www.outbackpower.com to download the software
Uses the HUB4™ or HUB10.3™ Communications Manager for stacking
Stackable in series (OutBack or Classic), parallel, series/parallel, and three phase configurations
Automatic neutral-to-ground bond switching
Listed to ANSI/UL 458 (5th Edition) and CSA C22.2 by ETL
Single AC input with dual input programming; individualized priorities can be selected when switching from
shore power to AC generator
external switching device required
system display required for individual programming
1
O
utback
P
ower
T
echnologies
I
ntuitive
C
ontrol
S
ystem for
R
enewable
E
nergy
