Oursson HB6060, Operation Manual

Page: 17 / 28

OPERATION
17
QUICK CLEAN
If you want to wash quickly the nozzle before
the next use, lower the whisk attachment in the
measuring cup half filled with water, and turn on
the device for a few seconds.
MOUNTING THE WALL BRACKET
You can attach the wall bracket as follows:
1. Drill two holes in the wall, by strictly adhering to
the dimensions shown in the figure below.
2. Hammer two dowels in the holes. Fasten the
bracket to the wall using two screws.
CLEANING AND MAINTENANCE
1. Disconnect the device from the outlet and
remove the nozzle.
2. Rinse the whisk attachment under running
water without the use of abrasive cleaners or
detergents. After washing, place the nozzle
vertically to dry it.
4 мм
48 мм
4 mm
48 mm
NOTE!
Do not dip the upper part of
whisk attachment in water as
the lubrication of the bearings
inside can be flushed.
3. Wash the chopping bowl, the measuring cup,
the whisk attachment and the knives in warm
soapy water. Whisk attachment and chopper
bowl are not recommended to be washed
in the dishwasher, as this will destroy the plastic.
4. Wipe the device with a damp cloth. Never
immerse it in water because of the danger
of electrical shock.
5. Thoroughly dry all parts.
6. Attach the whisk attachment to the motor unit
and place it vertically in the wall bracket as
shown in the figure.
NOTE!
The blades are very sharp,
be careful.