Oursson HB6060, Operation Manual

Page: 15 / 28

OPERATION
15
OPERATION
Before first use, wash the blender (see «Quick
Clean»). The time when the device idles shall
not exceed 15 seconds.
Before assembling or removing nozzles
ensure that the device is unplugged from the
power outlet. Maximum time of continuous use
of the device with a whisk or chopper should
not exceed 1 minute, then you should turn off
the blender for 3 minutes.
Maximum time of continuous use of the device
with a whisk for whipping must not exceed
2 minutes, then you should turn off the blender
for 3 minutes. The consecutive alternation of
these two intervals will provide reliable and
trouble-free operation of the device.
1. Assemble the necessary attachment device
as described above.
2. Plug the device into a power outlet.
3. Select the required speed by setting its
speed switch. The blender has a smooth
speed control (from low speed to high).
Then press and hold the on / off button.
4. You can also turn on the blender by holding
down the Turbo Mode. In this case, the
device will operate at maximal speed all the
NOTE!
The blades are very sharp,
be careful.
_
+
ни
зк
ая
средняя
вы
со
ка
я
POWER CONTROL
The device is equipped with a smooth speed
control. To change the speed, use the slider from
low to high in a clockwise direction.
lo
w
medium
high
time. The speed will not change even if you
change the position of the switch.
5. To switch off, release the Turbo Mode.
6. Unplug the power cord from the outlet.
7. Then you can disassemble the device.
You can open the lid of the chopper after
removing the motor unit.
8. After using the blender, place it in the large
hole of the bracket.