Otto Bock SKIPPI, Service Manual

Page: 32 / 72

Service Work
Skippi 32 | Ottobock
U
Remove the footrest / side panels (see section 6.8/6.5).
U
Unplug the controller cabling, unscrew the controller.
U
Remove the old seat (including the seat plate and seat frame; see Section 6.6).
U
Remove the bearing plates with back part (see Section 6.7).
For installation proceed as follows:
1. Push the assembly unit from the rear onto the base frame (see item A).
2. Screw the assembly unit to the base frame (see item B). For tightening you need a 5 mm
Allen wrench and a 13 mm open-end wrench.
3. Move / pull the lift seat up to make room for the installation (see item C).
B
B
A
A
C
Fig. 25 Attaching the assembly unit to the base frame and Installed/lifted seat height adjustment
4. Remove the retaining bar for the controller and install the alternative retaining bar (see item D).
Here you need a size 6 Allen wrench.
5. Before you are able to install the adjustment motor, you have to fix the holding device to the
base frame with six oval head screws with Allen head (see item E). Here you need a size 5
Allen wrench.
D D
Fig. 26 Installed retaining bar for the controller