Otto Bock SBK 104447.000, Manual

Page: 6 / 40

1 Foreword English
This document applies to the custom fabrication SBK 104447.000.
2 Product description
The U-shaped chest-shoulder bracket (see fig. 1, item 1) is used to mount mo-Vis joysticks for special control func­
tions. The joystick is attached to a retaining bracket (see fig. 1, item 2).
To use the chest-shoulder bracket, it is placed onto the user's shoulders and fastened on the torso with two upper
body harnesses (see fig. 1, item 3). The upper body harnesses are fastened with strap fasteners in front of the
torso (see fig. 1, item 4).
The joystick with the retaining bracket can be removed from the chest-shoulder bracket (see fig. 1, item 5),
for example, so the user can rest or eat without wearing the joystick directly on the body. There is no need for the
user to take off the chest-shoulder bracket.
Before use, the ends of the chest-shoulder bracket are shaped to the user's chest-shoulder region (see fig. 1,
item 6) and the strap lengths are adjusted by the qualified personnel.
3 Safety
WARNING
Failure to observe the instructions for use for the main product
Risk of accident and serious injury, damage due to failure to observe important information
► The additional documentation only applies in connection with the instructions for use for the main product. A
knowledge of all the documents is a basic prerequisite for proper use.
►
For this reason, all information regarding use has to be carefully read before using the product and all safety
notices must be observed.
WARNING
Improper handling of the product
Falling out, falling of the user, suffocation, uncontrolled driving, damage to the product due to user error
►
Always turn the control device off before putting on/taking off the chest-shoulder bracket, before
installing/removing the joystick and for all adjustments.
► Apply the chest-shoulder bracket so that the neck and throat area remain free at all times. Follow the position­
ing instructions.
►
Apply the chest-shoulder bracket so the ends/arms of the bracket are never between the body and the back
support. The upper body harness straps must always lie flat on wrinkle-free clothing without constricting. Oth­
erwise pressure points may occur.
► After taking off the chest-shoulder bracket or joystick, always store them in a safe position to prevent driving
off if the control device is still on or switched back on again.
► When the user is transported in a vehicle for transporting persons with reduced mobility, the chest-shoulder
bracket has to be taken off/removed for the duration of transportation.
4 Preparing the product for use
4.1 Notes on positioning:
Prior to assembly and adjustment of the chest-shoulder bracket, the user must be positioned correctly in the seat:
•
Place the user in an upright, 90° seated position (if physiologically possible).
• Ensure that the back is up against the back support pad (if physiologically possible).
• The chest-shoulder bracket is intended to be located in front of the torso area (sternum). Ensure that the U-
shape is at the height of the second to last costal arch to ensure optimum hold.
Possible application errors
• The chest-shoulder bracket is too close to the throat, endangering the user.
• The chest-shoulder bracket makes contact above the user's sternum (too high) or in the area of the soft tissue
of the abdomen (too low).
6
Foreword
SBK 104447.000