Otto Bock C2000, Instructions For Use Manual

Page: 19 / 72

7.3.7 Changing control unit parameters
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified personnel trained by the manufacturer. The manufacturer of
the product and the control unit manufacturer are not liable in case of damage caused by programming which
was not performed properly and/or which was not adjusted properly according to the user's abilities.
If necessary, the qualified personnel can adapt the preprogrammed wheelchair control unit and options to the con­
crete requirements of the user.
8 Use
8.1 Circuit breaker
INFORMATION
► Should the automatic circuit breaker deactivate repeatedly after activation for no discernible reason, contact
the qualified personnel.
►
For shipping or when the power wheelchair is not being used for an extended period of time, the automatic
circuit breaker should be deactivated.
The automatic circuit breaker has to be activated before the power wheelchair can be switched on.
It is located laterally on the drive unit sustainer, next to the charging receptacle (see fig. 10, item 1).
10
Activating the circuit breaker
1) Push up on the reset lever, which is at an angle,
until it engages (see fig. 10, item 2).
2) The circuit breaker is activated.
Deactivating the circuit breaker
1) Press the pushbutton (see fig. 10, item 3). The
reset lever folds up again diagonally (see fig. 10,
item 2).
2) The circuit breaker is deactivated.
8.2 Side panels
INFORMATION
For additional information on side panels with lighting: see Page 41.
The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.
8.2.1 Removing/installing the side panels
INFORMATION
To remove the side panels with lighting: see Page 41.
To make getting in from the side easier or for transportation, the side panels can be removed if needed.
Ottobock | 19 C2000
Use