Otto Bock C2000, Instructions For Use Manual

Page: 16 / 72

CAUTION
Lack of instruction
Injuries, malpositions, illness of the user due to information errors
►
The qualified personnel is responsible for making sure that the user and/or attendant/nursing staff has under­
stood the proper adjustment, use, maintenance and care of the belt system.
►
In particular, ensure that the user and/or attendant/nursing staff knows how to quickly loosen and open the
product to avoid delays in case of emergency.
Notes on correctly adjusting and applying the belts/belt systems: see Page 55.
7.2.4 Changing control unit parameters
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified personnel trained by the manufacturer. The manufacturer of
the product and the control unit manufacturer are not liable in case of damage caused by programming which
was not performed properly and/or which was not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configuration can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause an accident.
► After configuration/programming is complete, the user must test the driving characteristics of the product
under the supervision of the qualified personnel.
7.2.4.1 Wheelchair control options
If necessary, the programming of the wheelchair control unit can be adjusted to the specific user requirements.
Information on using the wheelchair control unit: see Page 24.
Troubleshooting information: see Page 62.
Further information on programming can be found in the 647G484=* service manual.
7.2.4.2 Attendant control
The power wheelchair can be ordered and equipped with an attendant control. It may be necessary to fit the
already installed attendant control to the actual body size of the attendant.
Information on operating the attendant control: see Page 16.
Troubleshooting information: see Page 64.
7.2.4.3 Push-button module
The power wheelchair can be ordered and equipped with a push-button module. The installation position of the
push-button module may have to be adjusted so that the user can reach it easily.
Information on operating the push-button module: see Page 16.
7.3 Adjustments by the user
The user may only perform the fine-tuning adjustments described in the following.
This fine-tuning should be carried out by attendants and only in the presence of the user. The user should sit
upright in the power wheelchair while adjustments are made.
All parts of the product should be cleaned thoroughly before adjustments are made.
The tools required for adjustments and maintenance tasks as well as the torque values for screw connections are
listed in the section "Appendices" (see Page 67 ff.).
7.3.1 Safety instructions
CAUTION
Screw connections not tightened
Pinching, crushing, tipping over, falling of user due to assembly errors
►
After all adjusting/readjusting work authorised by the manufacturer, retighten the mounting screws/nuts firmly.
Observe any torque settings which may be specified.
7.3.2 Adjusting the belt length
Notes on correctly applying and adjusting the lap belt: see Page 22.
Notes on correctly adjusting and applying the belts/belt systems: see Page 55.
16 | Ottobock
Settings
C2000