34
OTICOn InTIGA FITTInG GUIDE
35
For greater flexibility and patient comfort, use nEARcom
for a cable-free fitting of Oticon Intiga instruments.
note that programming of Oticon instruments requires
that the TM#1 module (870-10-030-00) is installed in an
available slot.
Detect the instruments
1.
Switch on the instruments using fresh batteries.
2.
Lay nEARcom on the table and place the instruments
in the middle of the neck loop in the orientation shown
here.
3.
Click Detect for cordless programming.
nEARcom
Instruments which have never been programmed must be
assigned to the correct side – left and right – in Genie.
Use a BEEP test as follows:
To identify the instruments place them in the middle of the
neck loop and click BEEP f.ex. for the left ear. The instrument
will beep for 6 seconds.
While the instrument is beeping, remove it (left instru-
ment) from nEARcom and listen to it.
If the instrument (left) does not beep, return it to the
middle of the neck loop, click Change side icon
1
and click
the same BEEP. Listen to the instrument (left) again.
Click Continue and proceed with the programming.
1
Cordless programming
Left
instrument
Right
instrument
min. 5 cm
