4
CAUTION:
Follow these important steps to assemble, tighten and mount CoolBlend
Jug quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE
EXPOSED.
1.
2.
3.
1. Turn container upside down so the
small opening is at the top.
2. Place Threaded Bottom Cap on Jug
and turn it clockwise to tighten.
3. Secure the lid & cap and place
assembly onto base. Position the
metal stop on the jar in front of the left
lug. Once you feel the jug drop into the
base and the blade assembly is just
below the surface of the metal ring, the
jug is ready to use. You may need to
twist the container to the left to secure
in place.
4. To remove simply lift straight upwards
out of the blender base. Do not twist.
DUE TO THE POWER OF THE
MOTOR ALWAYS PLACE ONE HAND
ON THE TOP OF THE CONTAINER
WHILE PROCESSING!
ASSEMBLING YOUR COOLBLEND JUG
CARE AND CLEANING OF YOUR OSTER
®
COOLBLEND JUG
Blender container parts are corrosion resistant, sanitary and easily cleaned. Before
first use and after every use, separate container parts by removing the threaded
bottom cap from the jar, and put the jar, cover, feeder cap, and threaded bottom cap
to clean thoroughly in warm, soapy water then rinse and dry well. Care shall be taken
when handling the sharp cutting blades during cleaning. After cleaning, assemble the
threaded bottom cap on jar properly.
Periodically check all parts before re-assembly. If the processing blades are stuck
or difficult to turn,
DO NOT USE BLENDER.
Check by carefully turning the blades
in an anti-clockwise direction
(opposite edges are sharp)
. Blades should turn freely.
If the container is chipped or cracked,
DO NOT USE BLENDER.
Further use could
result in the container breaking during use. Use only OSTER
TM
Blender recommended
replacement parts available at an Authorised Service Center.
USE OF DAMAGED OR NON‑RECOMMENDED PARTS COULD RESULT
IN SEVERE PERSONAL INJURY AND/OR DAMAGE TO THE BLENDER.
See Page 4 for proper container assembly and user instructions.
NEVER IMMERSE THE MOTOR BASE IN WATER.
The housing can be cleaned
with a damp cloth (unplug first). The motor is permanently lubricated and does
not require any additional lubrication.
ANY SERVICING SHOULD BE PERFORMED
BY AN AUTHORISED SERVICE FACILITY.
