OSS OSS-KIT-EXP-61611-xM, Installation Manual

Page: 2 / 46

One Stop Systems
OSS-KIT-EXP-61611-XM | 2
Table of Contents
Preface 4
Advisories 4
Safety Instructions 5
1 Introduction 7
1.1 Specifications 7
1.2 Parts of HIB616-x16 8
1.2.1 x4 cable Ports 8
1.2.2 HIB card seated flat (horizontal position) 9
1.2.3 HIB card seated in a vertical position 9
1.2.4 HIB Block Diagrams 10
1.2.5 Pin out assignments of the SFF-8644 PCB Connectors 11
1.2.6 Signal Descriptions 12
1.3 Features 12
1.3.1 Host Interface Board 12
1.4 SFF-8644 PCIe cable 13
2 Hardware Requirements 14
2.1 OSS-PCIe-HIB616-x16 card 14
2.2 SFF-8644 Gen4 x4 Cable 14
2.3 Expansion Chassis / Gen4 Backplane 14
2.4 Host Card Mode Configuration 15
2.5 Target Card Mode Configuration 16
2.5.1 Target mode switch settings - OSS-Backplane 16
2.5.2 Target mode switch settings - Magma-Backplane 16
2.6 Supported Setup 17
2.7 Use Cases / Configurations 17
2.7.1 Host-to-Host 17
2.7.2 Using 3
rd
Party Target Backplane 18
2.7.3 Connecting to 3
rd
Party backplane via on-board SFF-8644 connector 18
3 Installation Procedures 19
3.1 Tools Required for Installation 19
3.2 Configure Card to Host and Target modes 19
3.3 Install the Target card 19
3.4 Install the Host card 21
3.5 Connecting the Link Cables 22
3.5.1 x16 configuration: FOUR cables 22
3.5.2 x8 configuration: TWO cables 22
3.5.3 x4 Configuration: ONE cable 23
3.5.4 Disconnecting the cable 25