3
1.3 Safety instructions for installers
1.2 Safety instructions for users
!
WARNING
The overflow from the safety valves must NOT be sealed or plugged.
The product front and electric junction boxes must NOT be covered.
The product must NOT be modified or changed from its original state.
Children must NOT play with the product or go near it without supervision.
!
The product shall be filled with water before the power is switched on.
!
Maintenance/settings should only be carried out by persons over 18 years of age, with sufficient
understanding.
!
CAUTION
The product must not be exposed to frost, over-pressure, over-voltage or chlorine treatment.
See warranty provisions.
Maintenance/settings shall not be carried out by persons of diminished physical or mental capac-
ity, unless they have been instructed in the correct use by someone responsible for their safety.
!
WARNING
The overflow from the safety valves must NOT be sealed or plugged.
!
Discharge must comply with current building regulations.
!
The electrical supply to the heater shall be done in accordance with current local regula-
tions and best practice by a qualified electrician. The product is intended for permanent
supply.
!
The mains power supply cable shall withstand 90°C. A strain reliever must be fitted (supplied).
!
The product shall be filled with water before the power is switched on.
!
The relevant regulations and standards, and this installation manual, must be followed.
!
CAUTION
!
The cylinder must be installed in compliance with current building regulations. Liability for
consequential damage will only apply if this is followed.
!
The product shall be properly aligned vertically and horizontally, on a floor suitable for the
total weight of the product when in operation. See type plate.
!
The product must have a clearance for servicing of 400 mm in front of the electric junction
box covers / 150 mm above the highest point.
!
This document should be kept in a suitable place where it is accessible for future reference.
