SECTION 4: INSTALL THE LOCK
PG. 6 OF 8
PG. 3 OF 8
4-1
a. Remove the Face Plate and guide the Connector and the Lock into Mortise so that the Cable passes through the
slot above the Cylinder hole and the Lock is seated in the Mortise. Refer to Fig.9.
CAUTION: Do not pinch the Cable.
b. Mark the hole location for the Case Attachment Screws and remove the Lock from the Mortise. For Wood Doors,
drill 1/8" dia. pilot holes for Case Attachment Screws, and counter drill the holes 7/32" dia. x 3/16" deep for
Combination Screws. For Metal Doors, drill 3/16" dia. holes. Adjust the Front Bevel as required by loosening the
Screws at the top and bottom of the Case, set the Bevel and securely re-tighten the Screws. Install the Lock.
LOCK ASSEMBLY
MOTOR CABLE
CONNECTOR
(RED AND BLACK WIRES)
CASE
ATTACHMENT
SCREWS
THREADED POST
SHANK
THUMB
TURN
INNER INSERT
ASSEMBLY
SPINDLE & SPRING
ASSEMBLY
OUTER TRIM
ASSEMBLY
INSIDE
SCREW
#10-32 X 2”
OUTSIDE
INSIDE
HANDLE
SET SCREW
(INSTALLED)
COLLAR
ROSE
WASHER
FOOT
UPPER
RETRACT
ARM
CYLINDER
RETRACT
LEVER
COUPLING
LATCH BOLT
SPRING
HUB
“T” TURN
HUB
DEAD LOCKING
BAR
LOCK FRONT
SCREW
BLOCKER
ASSEMBLY
DEAD BOLT
PIN
FACE PLATE
4-2
ATTACH THE TRIM
a. Insert the Inner and Outer Spindle and Spring Assemblies into the Lock Hubs. Place the Outer Trim Assembly over the Outer
Spindle and Spring Assembly. Refer to Fig.10.
b. Place the Inner Insert Assembly over the Inner Spindle and Spring Assembly. Put the Screws through the Insert and thread
into the Posts of the Outer Trim until tight.
c. Place the Rose over the Insert, thread on the Collar and tighten with the Spanner Wrench. Place the Washer over the Outside
of the Shank. Put the Inside Handle on the Shank, and as you are pressing toward the Door, tighten the Set Screw in the
Handle until tight.
d. Install the Thumb Turn if required.
FIG.2
FIG.10
FIG.9
