SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
2-6
– JLG Lift –
3121132
GENERAL
Begin the “Walk-Around Inspection” at Item 1, as noted on the
diagram.Continue to the right (counterclockwise viewed from
top) checking each item in sequence for the conditions listed
in the “Walk-Around Inspection Checklist”.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE.
CHECKING THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDI-
TIONS WHICH COULD CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE:
On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visible
damage exists in addition to any other criteria men-
tioned.
NOTE:
All wheel lugs are to be torqued at 170 ft lbs (240 Nm).
1.
Oscillating Header Valve (2WD only)(If applicable) - No
unsupported wires or hoses; no damaged or broken
wires.
2.
Steer Cylinder - See Note.
3.
Spindle, Tie Rod and Steer Linkage - See Note.
4.
Wheels and Tires - Properly secured, no missing lug
nuts. Refer to Section 6, Tires and Wheels. Inspect
wheels for damage and corrosion.
5.
Drive Hub - See Note.
6.
Oscillating Axle, Oscillation Cylinder - See Note.
7.
Scissor Arms, Centering LInk and Sliding Wear Pads -
See Note.
8.
Fuel Tank - See Note.
9.
Main Control Valve - No unsupported wires or hoses;
no damaged or broken wires.
10.
Leveling Jack Valve (If equipped) - No unsupported
wires or hoses; no damaged or broken wires.
Figure 2-2. Walk Around Inspection Points - Sheet 1 of 2
