OSD Audio 2600P series, Operator'S Manual

Page: 152 / 160

OPTICAL SYSTEMS DESIGN
DOC ID: 10112303
OSD2600 OPERATOR MANUAL
PAGE 152
NTP Status:
5.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
6.
Usage:
Use
ntp enable
command to enable NTP for the Switch.
Use no ntp enable command to disable NTP for the Switch.
7.
Command Syntax:
(no) ntp enable
8.
Example:
The following example enables NTP for the Switch:
switch_a(config)#ntp enable
switch_a(config)#
NTP Server:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to specify the IP address or Domain name of NTP server.
3.
Command Syntax:
ntp server IP-ADDRESS
｜
DOMAIN-NAME
IP-ADDRESS A.B.C.D specifies the IP address of NTP server.
DOMAIN-NAME Specifies the Domain name of NTP server.
4.
Example:
The following example specifies the IP address ( 192.168.1.100 ) of NTP server:
switch_a(config)#ntp server 192.168.1.100
switch_a(config)#
Sync Time:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use ntp sync-time command to synchronize time with NTP server.
3. Command Syntax:
ntp sync-time
4.
Example:
The following example synchronizes time with NTP server:
switch_a(config)#ntp sync-time
switch_a(config)#