OSD Audio 2600P series, Operator'S Manual

Page: 106 / 160

OPTICAL SYSTEMS DESIGN
DOC ID: 10112303
OSD2600 OPERATOR MANUAL
PAGE 106
DLF:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use storm-control dlf enable command to enable destination lookup failure traffic.
Use
no storm-control dlf
command to disable destination lookup failure traffic.
3.
Command Syntax:
storm-control dlf enable
no storm-control dlf
dlf destination lookup failure
4.
Example:
The following example shows setting storm-control dlf enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control dlf enable
switch_a(config-if)#
STATIC MAC ENTRY
Static-MAC-Entry Forward:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to statically configure a bridge entry to forward matching frames.
3.
Command Syntax:
bridge GROUP address MAC forward IFNAME VLANID
no bridge GROUP address MAC forward IFNAME VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH format.
IFNAME the interface on which the frame comes in.
VLANID The VID of the VLAN that will be enabled or disabled on the bridge <2-4094>.
4.
Example:
The following example configures a bridge GROUP ( 1 ) to forward matching frames (MAC address
2222.2222.2222 ) to the interface fe1 (port 1) in vlan VLANID ( 2 ):
switch_a(config)#bridge 1 address 2222.2222.2222 forward fe1
vlan 2
switch_a(config)#