OSD Audio 2600P series, Operator'S Manual

Page: 124 / 160

OPTICAL SYSTEMS DESIGN
DOC ID: 10112303
OSD2600 OPERATOR MANUAL
PAGE 124
RING SETTING
Ring state:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable Ring state. Use the no parameter with this command to disable Ring state.
3.
Command Syntax:
bridge GROUP protocol ring
no bridge GROUP ring enable BRIDGE-FORWARD
GROUP <1-1> Specify the bridge-group ID.
BRIDGE-FORWARD Puts all ports of the specified bridge into the forwarding state.
4.
Example:
The following example enables Ring state in bridge GROUP (
1
):
switch_a(config)#bridge 1 protocol ring
switch_a(config)#
Set ring port:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set Ring port 1 and Ring port 2.
3.
Command Syntax:
ring set-port RING_PORT_1 RING_PORT_2
RING_PORT_1 Specify the Ring port 1.
RING_PORT_2 Specify the Ring port 2.
4.
Example:
The following example sets the fe1 and fe2 as Ring port 1 and Ring port 2:
switch_a(config)#ring set-port fe1 fe2
switch_a(config)#