14
the unit and evaporation of condensation water
indispensable for proper operation of the refrigerated cabinet, is under control of the electronic
compressor and allows the evaporator to eliminate any accumulated ice. The number of
set in the factory. Check periodically to make sure the cabinets are defrosted
ny malfunction call an expert.
s are equipped with an automatic evaporation system which eliminates the defrost water. At least
in the evaporator tray at the level of the motor compartment (this should be done with the
ade by the service personnel.
ical appliances inside the food storage compartments of the appliance, unless they are of the
anufacturer (IEC60335-2-89:2002 and changes)
rgent and dry with a soft cloth. Do not use inflammable or abrasive products.
arning:
Only plug the unit back in after checking that all parts (extracted or otherwise) are dry. Reload the unit following
operations should be carried out by expert personnel.
ned to authorised centres of assistance or qualified personnel.
binet.
oroughly: unplug it and empty it completely. Reach the evaporator as per drawings of FIG. 8 - 9 at page 3 and
plugging the unit in again, always check that all internal parts are completely dry.
abinet completely once a year.
re the switch on the control panel has been pressed.
Check the switch fitted above the plug (if any) is flipped.
bove checks, contact your nearest service centre and empty the unit (placing the
the air vents are unobstructed. If not read Par. 6.
e respected.
are fire-proof or
e dealer or Oscartielle S.p.A
8 - Defrosting of
The defrost cycle, which is
device, that temporarily stops the
defrost cycles (standard is 3 in 24 hours) is
automatically and in case of a
Castor Wood cabinet
once a month check the level
cabinet off).
Warning
: any adjustments or alterations should only be m
Warning
: Do not use electr
type recommended by the m
9 - Cleaning the unit
Warning
: before cleaning the cabinet unplug it from the power mains.
Periodically clean the cabinet with mild dete
Do not clean the cabinet with direct jets of water. When you clean the evaporator wear gloves to protect the hands from
possible cuts.
W
the instructions in point 6.
10 – Unit maintenance
Warning
: All maintenance
Warning
: Unplug at the mains before servicing.
Warning
: Other maintenance operations, (not described herein) including replacement of lamps with lamps of the same
model, have to be commissio
Clean the condenser once a month, after removing the protective grating on the rear of the cabinet (FIG. 13 page 4). Use
a brush with stiff bristles (not metal) or a vacuum device, which is even better, to eliminate any deposits of dust between
the fins. When you clean the condenser wear gloves to protect the hands from possible cuts. After cleaning, replace the
grating previously removed. Leaving the condenser dirty for long periods leads to higher energy consumption and poor
performance of the ca
We recommend having a refrigerator expert check the cabinet completely once a year.
Ice may form on the evaporator after long periods of use preventing proper operation. Every three months, clean the
cabinet th
FIG. 10 – 11 at page 4. Wait for the ice on the fins of the evaporator to dissolve completely and clean all parts of the
cabinet and then carefully clean with a soft bristle brush. Again, always wear protective gloves to avoid cutting your
hands. Before
We recommend having a refrigerator expert check the c
11 - Emergencies
Warning
: if the cabinet should stop or fail to start
- Make sure there is not a situation of electrical black-out
-
Make su
-
If the problem persists despite the a
products in suitable storage cells to avoid breaking the cold chain).
Warning
: if the cabinet does not chill sufficiently
- Make sure the condenser is clean and capable of performing its heat exchange function. If not, read Par. 10.
- Make sure the cabinet is correctly loaded and that
- Make sure the evaporator is not covered with ice. If not read Par. 10.
- Make sure the cabinet is not close to a draft or heat source (see Par. 3).
- Make sure the cabinet is level and the environmental conditions listed in Par. 3 ar
If after checking all these things the problem persists, call the nearest service center.
Warning
: Never approach the motor compartment in the event of leaking gas or a fire. Unplug at the mains. Never use
water to put out any flames, but only dry powder extinguishers. All the materials used to build the unit
self-extinguishing and non-flammable.
12 - Accessories
The Castor Wood units can be fitted with the following accessories on request.
-
Front and side tubular bumper rail.
- Plexiglas
dividers.
-
Adhesive transparent ticket channels on working shelf.
-
Support for promotional panels.
If interested in purchasing any of the above accessories, contact your nearest Oscartiell
directly.
