Oscartielle Castor Wood Instruction Manual Download Page 15

Page: 15 / 48

5. Frequency
6. Max absorbed current

. Max absorbed power

ring defrosting

rective 89/109

the display unit has been tipped during positioning and installation, wait at least three hours before starting it up in order

n the compressor! The refrigerating unit may be irretrievably damaged if

d 3 above.

d outside and clean the cabinet according to the

and illumination of

closed to

suitable for the conservation of the products placed in the display

is designed for the display of food products, which are stored at the temperature of the product, and does not

e product should therefore be placed in the cabinet only after it has been chilled to its proper storage

th the existing ones.

This

ways be drained into the sewer system or treatment plant in accordance with the laws in force.

not explicitly indicated in this manual is to be considered hazardous and the manufacturer

ctrical appliances inside the food storage compartments of the appliance, unless they are of the

ns (including children) with reduced physical, sensory or mental

pervision or instruction concerning use

nce.

such as aerosol cans with a flammable propellant in this appliance.

7
8.  Max absorbed power du
9.  Standard lighting power
10.  Net display area
11.  Type of cooling gas used
12.  Weight of cooling gas loaded in each unit

3. Climatic class and reference temperature (dry bulb)

1
14.  Electrical safety factor
15. Work schedule number
16.  Work order number
17.  Year of manufacture

Important

: The rating plate and warning labels should never be removed. The manufacturer is not liable for any damages

caused by failure to respect this regulation.
This is to certify that the product complies with Legislative Decree no. 108 of 25/01/1992 applying EEC Di
concerning materials and objects expected to come into contact with food products.

6 - Loading and use of the unit (start-up)

If
to give the lubricating oil enough time to collect i
this precaution is ignored.

lying with points 2 an

The display unit can only be started up for the very first time after comp
With the cabinet off, remove the plastic film protection on the inside an
instructions in paragraph 9.
Plug it into the mains (as described in Par. 4) and switch the cabinet on. The gentle hum of the motor
the display will indicate that the cabinet is working. The display (FIG.7 page 2) on the rear casing shows the working
temperature of the display case. The instruction manual for the electronic control to which the display refers is en
the instruction manual (tampering with this device is impossible because a password is required and only a specialized
expert can modify it).
About three hours after switching the cabinet on, you can start filling it with products. Always check that the temperature
reading on the display of the electronic control is
cabinet.
The cabinet

wer it. Th

lo
temperature.
For better conservation of the product we recommend:
-

Do not obstruct the cold recycle vents that ensure a correct air flow.

When placing more products inside a partially filled cabinet, in addition to following the above instructions, it is a good
rule to place the new products undernea

The thermostat and gas charge are set in the factory. Tampering with the factory settings relieves the manufacturer of
any liability.

7 - Prohibitions and requirements
Warning

: disconnect the cabinet from the power supply in case it is not used. The power supply has to be disconnected

by the remote-control switch fitted upstream from the power socket.

Warning

: do not expose the cabinet to atmospheric agents, never use jets of water to clean it, do not touch and use the

cabinet with wet or damp feet or hands.

Warning

: do not remove guards or covers that require tools to remove them, never remove the cover on the power panel.

Warning

: do not place heavy loads in the cabinet, and never climb on the counter top.

Warning