Orwak 490 1040-00, Original Operating Instructions

Page: 23 / 28

23
1
2
3
4870531-00
To be placed at
the cover of the
power supply.
To be placed
inside the door.
1
2
3
4870531-00
To be placed at
the cover of the
power supply.
To be placed
inside the door.
English
SAFETY CHECKS
- Check that all covers
and guards are intact.
- Check the function of
the magnet switch on
the door by opening
the door during a
compaction cycle . The
machine should then stop
immediately.
WEEKLY INSPECTION, CLEANING AND MAINTENANCE
CLEANING
Protective gloves must be worn at all times when
working inside the emptying hatch. Use a damp cloth
to clean the outside of the machine, press plate, feed
hatch and the area around it.
NOTE!
During
inspection,
cleaning,
maintenance and
servicing, and when
removing trapped
waste, etc., disconnect
the power supply to the
machine by pulling out
the quick-connector on
the rear of the machine, or by pulling out
the plug. Do not direct running water into or
onto the machine.
- Check that the power cable is intact and
properly protected against impact.
- Using a folded newspaper or similar, check
that the feed hatch opens again if anything is
trapped in it.
- Check that the machine is standing steady.
If any faults are discovered in the functions listed
above, the machine must not be used until it has
been repaired by authorised service personnel.
Servicing and repairs must only be carried out
by qualified and competent personnel, and in
accordance with the machine manufacturer’s
instructions .
SERVICING
Servicing should be carried out at least once a
year, or when requested by the machine (steady
blue light when the door is open).
11