CHAPTER 5
-
CHARGING THE RZ1000 BATTERIES
Read the charger manual before using it.
Warning: If you use a charger other than the one supplied with your RZ1000 ask
your dealer for instructions.
CHARGING BATTERIES
(see Figure C)
1. Insert the charger plug (8) in the charging socket (10) located on the right side of the
tiller column.
2. Plug the charger power cord (9) into a wall socket (11).
3. When charging is complete, remove the charger power cord (9) from the wall socket
(11) and then remove the charger plug (8) from the charging socket (10).
4. Under ideal storage conditions, batteries that were charged to full capacity and were not
used should be recharged every month.
5. If you expect not to use your
RZ1000
for an extended period of time, we recommend
charging it for two days and then disconnecting the batteries.
6. If you have not used your
RZ1000
for an extended period of time, charge the batteries
for at least 24 hours before driving.
Note: There is NO need to disconnect the charging plug immediately after the
charging is complete.
However, DO NOT leave the charger connected to the batteries FOR MORE THAN
TWO WEEKS.
As long as the charging plug is in the charging socket, the electronic control of
the RZ1000 automatically cuts all power to the electric system and it cannot be
driven.
The charger supplied is suitable for charging lead acid dry/gel batteries. Use
only the defined type of charger. Before using any other type of charger, check
with your dealer.
Figure C
Summary of Contents for RZ1000
Page 28: ... ...