After stopping
After stopping the
RZ1000
, turn the key switch to OFF and
remove the key. The ON LED will turn off .
Note:
The EMB locks automatically when the throttle control lever is
released and the
RZ1000
has come to a complete stop.
Safe driving
When driving on ramps, high curbs and on sharp turns, drive very
slowly and carefully, preferably with the speed set to MIN.
When going up or down a step, always drive so that the wheels are
fully perpendicular to the step and both of the rear wheels meet the
step at the same time.
Never try to go on an obstacle that is more than the maximum
recommended slope or curb height (see the stabilities and the obstacle
climbing specifications given in specification Sheet)
Always drive
carefully and adjust your speed to the road conditions.
Before making sharp turns, reduce speed to minimum to prevent
side roll-over.
Climbing an
obstacle
To climb an obstacle, drive the
RZ1000
forward toward the obstacle
until the front wheel touches the obstacle, then, maintaining your
direction, increase speed.
Prior to use
After reading through this entire manual and before using the
RZ1000
,
do a visual check of all the parts of the vehicle, to make sure that there
is no visible damage. If you have any questions or concerns, contact
your dealer.
Controller
programming
Several parameters of the
RZ1000
controller can be programmed.
Programming must be done by trained authorized technician only.
Incorrect programming can cause abnormal operation of the
RZ1000
and may result in damage and personal injury.
Prior to use
Before using the Breeze C, be sure you know your own weight and the
weight of any items you will be carrying on it. The maximum total load
is 150kg (330lbs).
Performance
check
A performance check is highly recommended when you first receive
Your
RZ1000
or after a period of not using the
RZ1000
,
as follows:
1. Turn on the key switch.
2. Verify that both the ON LED and the battery status indicator are
lit.
3. Slowly squeeze the drive control lever and verify that the
RZ1000
travels at a speed that corresponds to the degree to which you are
squeezing the lever.
4. Release the throttle control lever and verify that the
RZ1000
stops
smoothly, and that you hear the click of the EMB engaging.
5. Check that all the buttons on the dashboard work correctly.
6. Switch off the key switch.
Your
RZ1000
is now ready to drive.
Summary of Contents for RZ1000
Page 28: ... ...
