FIGURE B
(Numbers refer to Figure B )
Battery status
Indicator (#1)
The battery status indicator is located on the tiller panel and shows you
the remaining capacity of the batteries. Like petrol gauges in cars, the
indicator is not absolutely accurate; it is merely a guide to help stop you
running out of fuel. The accuracy of the indicator also depends on the
type and age of the batteries.
When the indicator shows 4 bars, recharge batteries as soon as
possible.
When the indicator shows 2 bars, recharge immediately.
Maintenance
LED (#2)
When the LED is flashing, it blinks the code of the fault.
Speed limit dial
(#3)
The speed limit dial is located on the handlebar panel.
When the speed limit dial is set to MAX, the
RZ1000
will drive at
approximately 15 km/hr.
When the speed limit dial is set to MIN, the
RZ1000
will drive at
approximately 3 km/hr.
Do not change the speed limit dial setting while the
RZ1000
is
moving.
Note:
Set the speed limit dial to MIN:
Until you get used to driving your new
RZ1000
,
and
When driving the
RZ1000
inside a building or in a crowded area
High – Low
Speed mode
Switch (#4)
Set the maximum speed of the scooter to HIGH or LOW speed.
Use the LOW speed mode when driving in close and crowded
areas.
Lights ON LED
High / Low speed indicator
Power indicator
(#2) Maintenance LED
(#3) Speed limit dial
(#4) High / Low
speed mode switch
(#6) Right turning
(#6) Left turning
(#9) Automatic
Freewheel switch
(#10) Lights ON switch
(Head and rear lights)
(#7) Hazard button
(#8)Buzzer
(#5) Throttle
Control Lever
(#5) Throttle Control Lever
(#5) Throttle Control Lever
(#1)Battery Status
Indicator
Summary of Contents for RZ1000
Page 28: ... ...
